How To Remove Rear Wheel On Cub Cadet Riding Mower

David Sacks/Digital Vision/Getty Images

A riding mower is preferred by many people with medium to big lawns. The Cub Buck LT 1045, for instance, helps take the strain out of grass cutting. When a apartment tire interrupts your grass cutting, remove the wheel and tire for repair. You will salve fourth dimension and money by doing the job yourself.

Step 1

Park the Cub Cadet mower in an area of the grand where the ground is level, with firm ground to support raising the mower with a jack. Consider parking the mower on a driveway as an culling. Turn the mower off, get out the manual in gear and fix the parking brake for safe.

• A riding mower is preferred by many people with medium to large lawns.
  
• When a flat tire interrupts your grass cutting, remove the bicycle and tire for repair.

Pace 2

Heighten the engine hood, locate the spark plug wire with the rubber kicking on the end and pull it from the spark plug tip for safety.

Step iii

Set a jack on the footing nether the front or rear of the mower frame, based whether a front or dorsum tire needs to exist removed. Position the jack and then information technology is in the center of the frame at the front or dorsum of the mower for stability.

Step four

Enhance the jack following the manufacturer'due south instructions. Insert the jack handle into jack and enhance the jack until it contacts the mower frame. Proceed raising the mower, and then slide a masonry block under the frame. Lower the mower frame on to the block for support while working.

• Raise the engine hood, locate the spark plug wire with the safety kicking on the terminate and pull information technology from the spark plug tip for condom.
  
• Set a jack on the ground under the front end or rear of the mower frame, based whether a front or back tire needs to be removed.

Footstep 5

Remove the bumper cap from the end of the beam when removing a forepart tire. Apply pliers, if necessary to help remove the cap, so pull the cotter pin from the front axle. Pull the bicycle and tire assembly off the beam.

Step vi

Remove the hubcap on the rear axle, if a rear bicycle is being removed. Loosen and remove the hex head bolt with a socket wrench and 5/16-inch socket. Plough the bolt counterclockwise to loosen and remove. Pull the bong washer and flat washer off the rear axle. Slide the wheel and tire assembly off the beam.

• Remove the bumper cap from the end of the axle when removing a front end tire.
  
• Pull the wheel and tire assembly off the axle.

Step 7

Obtain a replacement bike and tire assembly from a mower repair shop, or accept a damaged tire repaired at a mower repair store or service station. Place the wheel and tire assembly back on the axle.

Pace 8

Place the flat and bell washer on the rear axle and secure it with the hex commodities. Identify the cap on the end of the axle. Secure the front tire in place with the washer and cotter pin, followed by the hubcap. Use pliers, if necessary, to push button the cotter pin back through the axle.

Step 9

Raise the mower with the jack and remove the masonry block. Lower the mower to footing with the jack. Connect the spark plug wire back to the spark plug.

• Obtain a replacement wheel and tire assembly from a mower repair shop, or accept a damaged tire repaired at a mower repair shop or service station.
  
• Place the flat and bong washer on the rear axle and secure it with the hex bolt.

Use circumspection when working around the mower even when supported by the jack or masonry block.

Source: https://www.gardenguides.com/cub-cadet-lt-1045-tire-removal-14555.html

Share this post